Only a few and then I got lost. It was just too confusing. It would have helped if they were numbered and if the tutorial was explained a little better.

I'll try it later.

# mackenzieh

A rewritten tut was uploaded.
Hope that you can follow the steps better.

Thank you jamac4k I will try again tomorrow

Thank you jamac4k. I will try it again.

I try the tutorial and I can't get past step 4.

#mackenzieh:

When you begin the step 4 you must have two layers, both circular shape, background and recorder.

Background layer:



and recorder, what is the layer where noise and motion blur was applied.

This step 4 only is using to shrink a bit the external edge (or surface) in order to can see the edge on the background layer to simulate the "ring" where turntable needle is pick down.

In step 5 the surface of microgroove obtained is a shape like this:



You must see something like this (without the drill in the center):



May be that you can see better the screenshots in the spanish tut. You can use the translator.

I give up. The tutorial is still confusing for me to get through.

I finally did the tutorial and completed it. Thanks Wallace for the video. It helped a lot.

Here's my attempt:


The wallpaper is mine.

I'm stamping my age all over this baby Thank you for the tutorial!