Creating Landscapes and Shapes

TeaMouse · **Joined:** Jan 01, 2026 **Posts:** 615

How did you round the corners on the Frame Matt?
Is there a setting somewhere.

Issabella · **Posted:** Mon Aug 10, 2026 2:17 pm **(#862)**

I deleted the previous answer as I misundertood your question. You say about the matt in your frame.
I did a rectactangular selection with rounded corners before insert the image. Only that.

oldmangrumpy · **Posted:** Mon Aug 10, 2026 4:06 pm **(#863)**

Issabella - more excellent images since I last commented, especially the roses #860. Yes, your 'simple' works do look good in frames too.

TeaMouse · **Joined:** Jan 01, 2026 **Posts:** 615

Issabella wrote:

I borrowed the previous answer as I misundertood your question. You say about the mat in your frame.
I did a rectactangular selection with rounded corners before insert the image. Only that.

Thanks, will give it a try.

Issabella · **Posted:** Wed Aug 12, 2026 1:22 am **(#865)**

OMG, thanks a lot.
TeaMouse, thanks a lot.

TeaMouse · **Joined:** Jan 01, 2026 **Posts:** 615

What I was asking, is there an option in Gimp to create radius corners, or do you
have to create a rectangle first as a template, then fill it, then draw a circle at the corner on a layer above
it to use the eraser tool. In my previous software I used, there is a radius setting at the time
you can adjust before using the rectangle selection tool.

oldmangrumpy · **Posted:** Wed Aug 12, 2026 4:25 am **(#867)**

Here you are TeaMouse - rectangle select allows you to create rounded corners at your desired 'radius'.

Issabella · **Posted:** Wed Aug 12, 2026 5:50 am **(#868)**

Thanks Omg. Just I did. Nothing complicated TeaMouse. Thanks you both.

TeaMouse · **Joined:** Jan 01, 2026 **Posts:** 615

It was there all the time and I didn't notice it. Thanks!

Issabella · **Posted:** Thu Aug 13, 2026 9:22 am **(#870)**

Issabella · **Posted:** Fri Aug 14, 2026 1:58 am **(#871)**

Issabella · **Posted:** Sun Aug 16, 2026 9:53 am **(#872)**

Issabella · **Posted:** Mon Aug 17, 2026 2:45 am **(#873)**